HJEM

YDELSER

PRODUKTER

 

 

 

 

 

MOORE PRODUCTS CO.

  • Regulators
  • Relays
  • Volume Boosters

 

Use the link below to get more information

Send information about Moore pneumatic

Series 61 Booster Relays

  

Series 61 booster relays are normally used to reproduce signals in a 1:1 ratio to provide signal isolation or increased flow capacity. A wide range of models is available to meet various application requirements. These include increasing the stroking speed of pneumatic valves, low pressure selection, and the accurate transmission of measurement signals.

Series 62 Constant-Differential Relays

  

Series 62 relays act as air flow controllers and maintain an essentially constant air purge for each setting of an integral needle valve. By maintaining a constant pressure drop across a built-in needle valve an essentially constant volumetric rate of air flow is assured.

Features
Bubbling rates held constant maintaining high accuracy of measurement
Wider needle valve openings are less subject to clogging
Full air supply (up to 100 p.s.i.) is connected to the purge system providing a greater margin of safety

 

Constant Differential Flow Controllers Series 63

  
Used in conjunction with an external needle valve, Series 63 instruments proŽvide constant volume flow rates for either liquids or gases over a continŽuously adjustable flow range.

For gases, models are available for either constant up-stream or constant down-stream pressure.
Available with either brass bodies and Neoprene diaphragms or 316 stainless steel bodies and Kynar diaphragms

Model 66 Amplifying and Reducing Relays

  
Series 66 pneumatic relays are fixed ratio instruments used to amplify or reduce control circuit pressure signals.
For example a 3-15 p.s.i. control signal can be amplified to operate a 6-30 p.s.i. control valve; or reduced to operate a low pressure device.
Models are available to amplify or reduce in the ratios of 2, 3, 4 or 6 to 1.

Model 661 Amplifying Relays with Bias

  
Series 661 are fixed gain amplifying relays with an adjustable bias. This permits both the input and output signals to have a common low limit. For example with a 2:1 ratio a 3-15 p.s.i. input can give a 3-27 p.s.i. output. Fixed ratios of 2,3,4 and 6 to 1 are available, as is a reverse acting version which gives decreasing output for increasing input

Pressure Regulators Series 40, 41 and 42

  

Moore NULLMATICŪ pressure regulators are widely used for precise pressure regulation in pneumatic systems. Their unique two-stage piloted design and rugged, frictionless construction provides accurate regulation with reliable, maintenance-free operation.

Series 40,41 and 42 regulators have diaphragm type sensing elements and provide a wide range of output of pressures and flows. Models are available for regulated outputs ranging from 1" WG to 450 p.s.i. Output flow capacities vary with the model, supply pressure and set pressure. Typically a maximum flow of 125 Scfm can be given by a 30 p.s.i. range instrument set at 25 p.s.i. and with a 100 p.s.i. supply.
 

Use the link below to get more information


Send information about Moore pneumatic